The management software micrometeorologica stations (both to 16m is that at 10m) was developed at ISAC-CNR, and can operate on two types of sonic anemometer is: R3 Gill and Gill 1012R2 operating respectively at 100 Hz to 20.8 Hz

The technical characteristics of these anemometers allow the acquisition of synchronous meteorological parameters from other sensors, allowing you to dispose of in a single data set. In accordance with the purposes of research, he has created a software tool to control them remotely interfaced with both models you have, that can simultaneously monitor up to 3 of the same model. The output of the system is represented by high frequency data saved in raw mode, and online calculators flows stored in ASCII files. The experimental setup is characterized in the first instance by the number of anemometers mounted and the type of the same. For each analog input are also included the factor of gain and any offset of the measure, so you immediately have statistics for the physical quantities, and can more easily control the operation of the instrument. In relation to the output file, then also select the order in which the statistic that should appear. In the calculation of statistical moments is important to correlate the measures with measures of quantity anemometric scalar sensors made with quick-response, which often operate with non-linear response, it is necessary to typify the code so that they can support. Currently supported is the Campbell KH20 and Licor LI7500. In remote measurement sites is important to monitor the operation of instruments quickly, and therefore without the download of data, the best way to do this is by viewing the graph of the last measurements, as shown in the graph on the left plot in figure; for a full audit of the transmission and reception dall'anemometro Instead, it is appropriate to monitor the complex of bytes lost reception than expected.